{{results.messages.text}}
5.3 Chevy engine. Low 130xxx miles4x4 automatic trans.Push button transfer case3.73 gearsG80 lockerMuch moreThis is what is left of a 2002 Z71 1500You get everything that is left of this truckCheck picsWont startHit hard front rightBring a rollback this will be hard to load on a trailer$1500 cash FIRMSerious inquiries onlyAd will be removed when soldGMC sierraC10Camaro ChevelleLS swap
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112102,5-3-Chevy-LS-motor-transmission-computer-much-more-engine-swap----1500--Davenport-.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
Merlin 3 tall deck,steel splayed caps, 4.38 bore,Ohio crank billet 4340 4.00 stroke, Bill Miller 6.8 alum rods, toolsteel wrist pins, total seal rings, SRP pistons, .800 lift cam, Jesel solid roller lifters, Jesel cam drive, Jesel rocker assemblies on Dart 380 Pro 2 heads with PAC springs and retainers and seats Manton lash caps, Manton pushrods, blower manifold, setback plate for 14-71 Kuhl Bl...
{{results.messagesById['https://www.racingjunk.com/BBC-complete/183051272/BBC-Blower-motor.html']}}
Ford MOTORSPORT SVO POWER. -----460 SVO CRATE MOTOR. Heads M-6049-429 Cobra Jet Aluminum Water Pump F 4TZ-8501-B , Intake - M-9424 - G429 Intake . Block - M- 6009- C460. 560 UP @ 6,000 RPM. -------------- 535 TORQUE @ 4750. Factory Run Time IS 20 Minutes . Also have 2 New 600 CFM Holley Carburetors . New Dual Quad Manifold Intake . Have another Single plan WEIAND Intake. This is ALL NEW. Engine...
{{results.messagesById['https://www.racingjunk.com/BBF-complete/183038907/SVO-460-Complete-Motor.html']}}
Condition: Used This motor clamp is from fresh water, includes trim and tilt lifting device, and it includes the mid section of the outboard casing and the upper exhaust manifold housing plat, any question call Pete 563-508-1758, all parts are in very good condition, reason for saling driveshaft broke just below the stator from weakness not an impact.
{{results.messagesById['http://www.2040-parts.com/yamaha-1998-50hp-4-stroke-outboard-f50tlhw-swivel-bracket-motor-clamp-i2148251/']}}
Condition: Used From fresh water , woks correctily no leakage Pete 563-508-1758 talk or text
{{results.messagesById['http://www.2040-parts.com/yamaha-1998-outboard-50-hp-4-stroke-f50tlhw-trim-tilt-motor-and-cylinder-i2154764/']}}
Item must be returned within: 14 Days Refund will be given as: Money Back Return shipping will be paid by: Buyer Restocking Fee: No Returns Accepted: Returns Accepted Return policy details: 95K Miles Removed from a 4/97 Jeep Grand Cherokee The crappy 42RE trans lost reverse so out came the engine You will be hard pressed to find an engine of this era with less than 100k on it I will Ship it Com...
{{results.messagesById['http://www.2040-parts.com/low-mileage-95k-jeep-6cyl-engine-motor-complete-wrangler-grand-cherokee-zj-xj-mj-i747822/']}}
Condition: Used 2003 MUSTANG COBRA 4.6 V8 ENGINE T56 TRANSMISSION DOHC SUPERCHARGED MOTOR 2.2 Kenne Bell Polished, JLT intake, Spec Clutch, MGW Shifter, Boost a pump, Aftermarket Radiator 55,xxx miles Great project for a resto Mod or newer mustang. Can provide Vin if needed. These are getting extremely hard to get a hold of in this shape. Its is equipped with 4.6L with all forged internals; pis...
{{results.messagesById['http://www.2040-parts.com/2003-mustang-cobra-4-6-v8-engine-t56-transmission-dohc-supercharged-motor-i2212155/']}}
: 2003/2004 MUSTANG COBRA 4.6 V8 ENGINE T56 TRANSMISSION DOHC SUPERCHARGED MOTOR 10,xxx miles on Built Motor and 71k on the rest Great project for a resto Mod or newer mustang. 10k miles on Built motor by P-51 Performance, S197 Aluminum Block, Cobra forged crank, Manley Forged rods and pistons, Bored .20 over with 9.3-1 Compression. 26 spline input shaft on transmissionwith a Ram Clutsh. JLT in...
{{results.messagesById['http://www.2040-parts.com/2003-2004-mustang-cobra-4-6-v8-engine-t56-transmission-dohc-supercharged-motor--i894761/']}}
: 2003/2004 MUSTANG COBRA 4.6 V8 ENGINE T56 TRANSMISSION DOHC SUPERCHARGED MOTOR 20,xxx miles 2004 Cobra Take Out 2.3 polished Whipple 3.00 inch blower pulley, Single Blade TB, 60lb injectors, Steeda idler pullies, MGW orange handle shifter, JLT intake, MAFIA and True Forged Coolant tanks. Show car quality Great project for a resto Mod or newer mustang. Test ran and sounds pretty strong for a h...
{{results.messagesById['http://www.2040-parts.com/2003-2004-mustang-cobra-4-6-v8-engine-t56-transmission-dohc-supercharged-motor--i23647/']}}
Similar
99 engine was replaced in 2016 with a new motor not a used motor a brand-new motor mileage is approx 35k price is $400.00 or best other engine also 4.3L has approx 132k for miles price is $300.00 or Best offer.. Have lots of parts contact me at
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,116429,1999-and-2003-GM-4-3L-Engines----1--Clinton-.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
full frame 81 monte carlo a little body work needed no motor trans body good for the year truely a solid car health problem or it would be done a big block 850 hp available if you need at added cost. no trans its up to you
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,115884,81-monte-carlo----800.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
parting 2010 ford focus good motor and tranny 102000 miles on mtor parts start at $1 phone calls only no text no emails phone only 5six3 508 4028
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112858,2010-ford-focus-parts----1--Davenport-.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
This is a heavy duty torque converter that fits a GM turbo 350 or 400 that was custom built for my 350 Chevy motor combination which was a mild street setup. It has less than 5000 miles on and it stalled around 1800 RPM which is about 500 RPM over a stock converter. I removed it and put a converter in with more stall.
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112859,Heavy-Duty-Torque-Converter-for-Turbo-350-or-400----125.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
Here is a Borg Warner 1356 transfer case that was pulled from a 1995 Ford F-350 4x4 truck with the 5.8L 351 motor and the E4OD automatic transmission. Was a running and driving truck, but was too rusted to keep on the road. Is a manual shift, not electronic.I can be reached at 8l5 2l8_6405Thanks for looking and God BlessRandy
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112862,Borg-Warner-BW-1356-Transfer-Case-From-1995-Ford-F350----150--Dixon--IL-.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
I have a 10 inch competition powerglide torque converter for sale that came from A-1 transmissions in California. This converter looks to be set up for a 14 motor plate, has powerglide splines, and the fluid looks good. The stall RPM will be determined by the torque of your motor. I am asking $120 or best offer Thanks for looking
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112863,10-inch-A-1-Competition-Powerglide-Torque-Converter----120--Fulton-IL--.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
This listing is for the E4OD transmission only, I am not selling the entire truck I will update the listing with pics of just the transmission when I have them available.Here is an E4OD transmission from a 1995 F-350 truck with the 5.8 351 motor. Unsure of miles. This trans shifts great, all 4 forward gears plus overdrive and reverse. Motor has been sold, so truck is no longer able to be driven...
{{results.messagesById['https://www.shoppok.com/quadcities/a,43,112090,1995-F350-E4OD-Automatic-Transmission----550--Dixon--IL-.htm?utm_source=ClazAutos&utm_medium=feed&utm_campaign=global&trmsource=clazoutfeed']}}
Condition: Remanufactured RE AD T HE ENTIRE AUCTION!!! * This is a motor rebu ilding program for the Yamaha Blaster 200 . * The way this w orks is you must first call Mark Brenny at 563-359-7222 (m-f 9am-6pm, sat. 9am- 3pm) and explain the condition of you r engine that you will send in. * DO NOT CLICK THE BUY IT NOW. F IRST CALL MARK BRENNY! Rebu ild prices vary depending on the condition of y...
{{results.messagesById['http://www.2040-parts.com/yamaha-yfs200-blaster-200-engine-rebuild-i2128608/']}}
Condition: Remanufactured RE AD T HE ENTIRE AUCTION!!! * This is a motor rebu ilding program for the Rhino 700 Engine * The way this w orks is you must first call Mark Brenny at 563-359-7222 (m-f 9am-6pm, sat. 9am- 3pm) and explain the condition of you r engine that you will send in. * DO NOT CLICK THE BUY IT NOW. F IRST CALL MARK BRENNY! Rebu ild prices vary depending on the condition of you e...
{{results.messagesById['http://www.2040-parts.com/yamaha-rhino-700-engine-atv-rebuild-i1664003/']}}
Condition: Remanufactured READ THE ENTIRE AUCTION!!! * This is a motor rebuilding program for the Yamaha Raptor 660 Engine. * You will be sending your blown up engine to be rebuilt. * The way this works is you must first call Mark Brenny at 563-359-7222 (m-f 9am-6pm, sat. 9am-3pm) and explain the condition of your engine that you will send in. * DO NOT CLICK THE BUY IT NOW. FIRST CALL MARK BREN...
{{results.messagesById['http://www.2040-parts.com/yamaha-raptor-660-engine-atv-rebuild-i1663993/']}}
Post Ad
1 + ... Next >